Lcd (Digital) - Arctic Cat 350 Manual

Horn Button
To activate the horn, press the horn but-
ton.
Starter Lever
Pulling this lever activates the starter
motor. Before starting the engine, make
sure the ignition switch is in the ON posi-
tion, the transmission is in neutral, and
the brake lever lock is engaged.
NOTE: This ATV has safety inter-
lock switches which prevent the
starter motor from activating when
the transmission is not in neutral.
Throttle Lever
Control engine RPM with the position of
the throttle lever. Operate this lever with
the thumb. Pushing it forward increases
engine RPM and allowing it to retract
decreases engine RPM.
40 40 40 40
Throttle Limiter Screw
Throttle lever travel may be limited by
adjusting the throttle limiter screw. The
throttle limiter should be adjusted
according to the operator's skill and
experience. To adjust the throttle limiter,
use the following procedure.
1. Loosen the jam nut (A).
ACE-023A
2. Turn the throttle limiter screw (B)
clockwise to decrease engine RPM
maximum or counterclockwise to
increase engine RPM maximum.
3. Tighten the jam nut securely.
NOTE: The ATV is equipped with
ACE-004E
an RPM limiter that retards ignition
timing when maximum RPM is
approached. When the RPM limiter
is activated, it could be misinter-
preted as a high-speed misfire.

LCD (Digital)

NOTE: All segments of the LCD
will activate for approximately two
seconds when the ignition switch is
rotated to the ON position.
ACE-024A
ACE-028A
CF236B