Configuration Of Sp Switch - Atm Oc-12C - Sp Switch - IBM 9077 Get Connected

Table 25 shows the IP addresses used in our configuration.
Table 25. Configuration of SP Switch - ATM OC-12c - SP Switch
Adapter
SP Switch Router Adapter card 1
SP Switch Router ATM media card
(port 00) in GRF 400
SP Switch Router ATM media card
(port 00) in GRF 1600
SP Switch Router Adapter card 2
To successfully run this configuration, on every SP Switch Router a route to
the distant SP Switch network has to be set. On the nodes of SP2 and SP21,
respectively, routes to the nodes of the distant SP have to be set.
The media card adapters on the GRF routers should already be up and
running (according to Section 3.7, "Step-by-Step Media Card Configuration"
on page 86 and Section 4.3, "ATM OC-12c Configuration" on page 119). The
important settings are repeated here, nevertheless, to be on the safe side:
• On the GRF 1600 (ATM card in slot 2, SP Switch card in slot 3):
1. The file /etc/gratm.conf needs the configuration statements for the port
2. The file /etc/grifconfig.conf has the following entries:
3. The file /etc/grroute.conf has the following line:
4. The SP Switch Router Adapter card is connected to the SP Switch and
• On the GRF 400 (ATM card in slot 1, SP Switch card in slot 3):
224
IBM 9077 SP Switch Router: Get Connected to the SP Switch
used:
Traffic_Shape name=bigg_speed_high_quality \
peak=622000 sustain=622000 burst=2048 qos=high
Interface ga020 traffic_shape=bigg_speed_high_quality
PVC ga020 0/132 proto=ip traffic_shape=bigg_speed_high_quality
gt030 192.168.14.4
ga020 10.20.30.1
192.168.13.0
This sets the correct route to the other SP Switch network over the
ATM OC-12c interface automatically; of course, this route could also be
set manually every time the GRF is rebooted.
configured, too. Check with
and use if needed.
Eunfence
IP Address
192.168.13.4
10.20.30.2
10.20.30.1
192.168.14.4
255.255.255.0 -
255.255.255.0 -
255.255.255.0 10.20.30.2
SDRGetObjects switch_responds
mtu 65520
mtu 9180
on the CWS