Attaching Sp Switch Router Cables; Ethernet Cable - IBM 9077 Get Connected

***********************************************************************
* Log files that used to be archived by the /etc/{daily|weekly|monthly}
* scripts.
***********************************************************************
size=150000
logfile=/var/log/gr.console
size=11000
logfile=/var/log/gr.boot
7. Save all changes and reboot:
# grwrite -v
# reboot
8. After the SP Switch Router is up and running again, use
verify that the PCMCIA interface is available and the PCMCIA disk are up.
For a quick test, run
not complain about a missing /var/log/gr.console file, but instead will show
all entries and stay up running, giving updates of new entries to the file
onto the screen. To stop

3.4 Attaching SP Switch Router Cables

Three types of cables must be attached:
• The administrative Ethernet LAN cable
• The SP Switch Router Adapter card to SP Switch cable(s)
• The ground strap to the SP frame

3.4.1 Ethernet Cable

Route the Ethernet twisted-pair cable between the SP Switch Router unit and
the Ethernet hub, then connect the cable to the SP Switch Router control
board and to the Ethernet hub. See Figure 31 on page 80 on how this might
be accomplished.
If the setup is correct,
grconslog -vf.
, use Ctrl+C.
grconslog
csconfig -a
grconslog
Installation and Configuration
to
will
79