New Commands; New Commands (Root Executable) - IBM 9077 Get Connected

AttributeDescription
node_typeThis attribute is set to dependent for GRF and to standard for all
switch_max_ltuThis specifies the maximum packet length of data on the SP
switch_link_delaySpecifies the delay for a message to be sent between the

2.4.2 New Commands

To support the dependent node architecture, seven new commands were
added. These commands can be divided into two groups. The first group
must only be executed with root permission on the Control Workstation. The
second group can be executed by any user on any standard RS/6000 SP
node.
Table 5 shows a list of commands of the first group:
Table 5. New Commands (root Executable)
Command
endefnode
enrmnode
endefadapter
enrmadapter
enadmin
The first four commands all have the same characteristics, which are as
follows:
• The are part of the ssp.basic fileset.
• They must only be executed on the Control Workstation.
• They can only be executed by the root user.
• They only affect the current active partition.
• They only affect the SDR, unless the
not applicable to
• They return a code of 0 if successful, 1 if failed.
other RS/6000 SP nodes.
Switch; the default is 1024. Do not change this value for
any reason .
two furthest points on the switch; the default is 31. Do
not change this value for any reason .
Description
Define or change an dependent node
Remove a dependent node
Define or change an dependent node
Remove an dependent node adapter
Reconfigure or reset the dependent node
-r
).
enrmadapter
option is specified (this option is
Router Node
43