Some Maint Commands For The Ethernet Media Cards - IBM 9077 Get Connected

if-config:
Ethernet interface configuration.
Enumerated field, values:
autonegotiate: autonegotiate
10-half: 10 BaseT Half Duplex
10-full: 10 BaseT Full Duplex
100-half: 100 BaseT Half Duplex
100-full: 100 BaseT Full Duplex
super> set if-config = 100-full
super> write
CARD2/ written
super> quit
#
The configuration of the Ethernet card is now completed. Issue
and
grreset <slot_number>
and attached devices should work now. To monitor the card, use the
commands we found to be useful in the following section.

4.1.6 Some maint Commands for the Ethernet Media Cards

The
maint
card's slot number, which you may find with the
Prepare to use
• First, switch to
• At the
interested in. For a card in slot 7, this would be the command
• As a result, the following message along with the changed prompt is
returned:
Current port card is 7
GR 7>
• At this prompt
• To leave the
The following
maint 1
maint 101
maint 3
maint 4
. Communication between the GRF's Ethernet card
commands operate on the SP Switch control board and require the
with the following steps:
maint
's
maint GR 66>
prompt, change to the prompt for the specific card you are
GR66>
commands can be issued.
maint
prompt, enter
GR 7>
commands were most useful for us:
maint
-to view the list of receive side (RX)
-to view the list of transmit side (TX)
-to display configuration and status of all ports.
-to display media statistics for both the input side and the output side
for one or all eight interfaces. If you do not specify one interface,
grcard
prompt with the
grrmb
.
quit
commands.
maint
commands.
maint
Configuration of IP-Forwarding Media Cards
grwrite -v
maint
command.
command.
.
port 7
109