Automation; Sysex Automation; Controller Automation; Reset All Controllers - Lexicon MPX G2 User Manual

MPX G2 User Guide

Automation

SysEx Automation

Controller Automation

Reset All Controllers

MIDI Clock and
Clock Commands
JamMan NOTE
When the JamMan effect is loaded
(Delay block) the loop size will be
determined by the Beat Value
(number of beats) and the tempo of
the incoming MIDI Clock. Like the
original JamMan device, only one
Tap is required.
6-6
The MPX G2 will transmit SysEx automation messages when the System mode
MIDI Automation parameter is set to On. Virtually all changes made by front
panel operations are transmitted as MPX G2 SysEx messages. This is intended
primarily for use by editor programs and in configurations where it is desirable
for one or more MPX G2s to be slaved to a single MPX G2 acting as a master.
The current mode (Program, Edit or System) of the slave does not follow the
master, but the actual parameter values do. (SysEx automation can also be
stored on a sequencer and replayed in real-time. As a general rule, automating
more than two or three SysEx parameter changes at once is not recommended.)
To set up the MPX G2 to receive SysEx automation messages from another
MPX G2, or from a computer editor/sequencer, the transmitting and receiving
MPX G2s should be set up as follows:
Transmitting MPX G2:
Recieving MPX G2:
The Receive Device ID of the receiving MPX G2, and the Xmit Device ID of the
transmitting MPX G2 must match. The Receive Device ID is an Option of the
MIDI SysEx Receive parameter. The Xmit Device ID is an Option of the MIDI
Automation parameter.
For applications where it is desirable to "automate" changes made to MPX G2
effects with its own controls ( the Knob, Footpedal or Footswitch), we recom-
mend assigning the controllers to MIDI destinations (see Chapter 5: System
Controls MIDI Send) and recording the MPX G2 MIDI output with a MIDI
sequencer.
The MPX G2 recognizes the "Reset All Controllers" message. When received,
all patched parameters are reset to their stored values, or to the last front panel-
edited values. Patched parameters may also be reset from the MPX G2 front
panel —in System mode select Ctl Send from the MIDI menu and press
Options. (The message will be transmitted from the MPX G2 as well).
The MPX G2 recognizes incoming MIDI clock messages when the Edit mode
Tempo Source parameter is set to MIDI. Any Delay parameter set to
echoes:beat, or any LFO parameter set to cycles:beat, will be synchronized to
the tempo of the incoming MIDI clock.
MIDI Clock and Clock Commands (Start, Stop, Continue) are also available as
Dynamic MIDI patch sources. The value of MIDI Clock when used as a patch
source is a linear scaling of 0 to 127 (0 = 41 BPM and 127 = 400 BPM). The value
of Clock Commands when used as a Dynamic MIDI patch source is 1 for START
and CONTINUE and 0 for STOP.
System mode MIDI Automation set to On
(Default=Off)
System mode MIDI SysEx Receive set to On
(Default=On)
Lexicon