Table of Contents
Advertisement
166
COpy CONTROL DIAL
Removal and Replacement
1.
Remove the print head ribbon lifter (164).
2.
Tilt the assembly away from the print head and
remove the screw
II
,that holds the dial.
3.
Complete the operation by reversing the preceding
steps.
167
PRINT HEAD RETRACT RAMP
Adjustment
1.
Power off.
2.
Remove the printer front cover (110).
3.
Loosen the 2 retract ramp mounting screws
II
slightly.
4.
Move the carrier against the left side frame.
5.
Set the Copy Control dial
II
to
O.
6.
Position the' retrad ramp
II
so that the Copy
Control dial is 2.41 mm
±
0.13 mm (0.095 inch
±
0.005 inch) from the print head housing. Use a
code plate alignment tool (part 460028) as shown
II
to measure this setting. Tighten the 2 screws.
7.
Complete the procedure by reversing steps 1
and 2.
o
Print Head
Retract Ramp
Underside View of Printer in Service Position
166,167
Remove, Replace,
Adjust
2.41 mm
±
0.13 mm
(0.095 inch
±
0.005 inch)
•
Print Head
fI
Copy Control Dial
II
Code Plate Alignment
Tool (part 460028)
Maintenance
5256 MIM
1-51
Advertisement
Table of Contents
