Menu In Off-Line Mode - MUTOH VC-600 User Manual

3.3

Menu in Off-line Mode

Press [ON/OFF LINE] to switch to the offline mode
Offline For System Setup
[ FORCE]
[ OFFSET ]
[ DATA CLEAR ]
[
[ SPEED ]
[CUT TEST ]
The Control Panel
Force:80 gf
OK:ENTER
Offset: 0.275 mm
OK:ENTER
Clear Data Memory
N:Cancel OK:ENTER
move origin
]
X: Y:
Speed: 72 cm/s
Select: OK:ENTER
UP Speed: 72 cm/s
Select: OK:ENTER
Quality: normal
Select: OK:ENTER
Square Cut
Select: OK:ENTER
Repeat AAS Job
Select: OK:ENTER
Repeat Last Plot
Select: OK:ENTER
Pattern Setting
Select: OK:ENTER
Ratio Setting
Select: OK:ENTER
Blade Length Adjust
Select: OK:ENTER
5~600 with an increment of 5(gram force)
0.000~1.000 with an increment of 0.025(mm)
Speed:3~153 with an increment of 3(cm/s)
:3~153 with an increment of 3(cm/s)
UP Speed
Draft, Fair, Normal, Fine, Small Letter
Pattern: Arrow
Change: OK: ENTER
Ratio: 100%
Change: OK: ENTER
Set Length 0.00mm
Change: OK: ENTER
3-3
ValueCut Kullanım Kılavuzu
Pattern: Cross, Arrow
Ratio: 100%, 200%, 300%, 400%
Test Blade Holder
OK: ENTER
Test Blade Length
OK: ENTER
Turn CW , Turn CCW