Adjusting The Air Flow Direction - Technibel MPA9FIB0R5I Operating Instructions Manual

ADJUSTING THE AIR FLOW DIRECTION

HORIZONTAL (manual) Only for MP-MT-KPA-K models
The horizontal air flow can be adjusted by moving the
vertical vanes to the left or right, as indicated in the following
figures.
MP MODELS
Vertical vane
MT MODELS ONLY
Vertical vane
Left
KPA MODELS
VERTICAL VANE
K MODELS
This air conditioner is equipped with two air outlet grilles:
the upper grille with flap and the lower grille.It is possible
to let the fan of the lower grille run or stop by moving the
switch, placed inside the air intake grille panel, as shown
in the figure.
Grasp here to
move the vanes
Grasp here
Right
Left
Aesthetic
flap
Fuctional
flap
Right
UPPER POSITION:
Only the fan of the upper grille
is running.
LOWER POSITION:
Both grilles' fans (the upper
and the lower one) are
running.
Upper grille
Lower grille
VERTICAL (with remote control unit)
Make sure that the remote control unit has been turned on.
the FLAP button to select the flap function
Fixed:
six
position
The flap automatically closes when the unit
●
NOTES
is off.
The aesthetic flap automatically closes 3
●
minutes after the unit is switched off. (ONLY
FOR MT MODELS)
When the unit starts in heating operation,
●
the fan stops and the flap is in the 4 position
(if automatical oscillation is selected) until
the air being blown out of the unit begins to
warm. Once the air warms up, the flap
position and fan speed change to the settings
specified with the remote control.
CAUTION
Do not move the flap with your hands when the air
conditioner is running.
CAUTION
• Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
• Do not have the flap pointed down during cooling
operation. Condensation may begin to form around the
air vent and drip down.
11
Continous Automatical
oscillations oscillations
Press
EG