Setting The Timer; Setting The 1 Hour Timer; Adjusting The Air Flow Direction - Technibel MPAF99R5I Series Operating Instructions Manual

SETTING THE TIMER

A) HOW TO SET THE ON TIME
1. Press the SEL TYPE button once.
The ON and time indications flash.
2. Press the SET H button until the
designed hour is displayed.
Press the SET M button until the
designed minutes are displayed. The
display will change automatically back
to show the present time after 10 sec.
EG
3. Press the ON/OFF button to start the air
conditioner.
4. Press the TIMER SEL button to activate
the ON timer.
B) HOW TO SET THE OFF TIME
1. Press the SEL TYPE button twice.
The OFF and time indications flash.
2. Press the SET H button until the
designed hour is displayed.
Press the SET M button until the
designed minutes are displayed. The
display will change automatically back
to show the present time after 10 sec.
3. Press the ON/OFF button to start the air
conditioner.
4. Press the TIMER SEL button two times
to activate the OFF timer.
C) HOW TO SET A PROGRAM FOR
DAILY ON/OFF OPERATION (OR
VICEVERSA)
1. Set the timer ON/OFF as shown in A)
and B).
2. Press the ON/OFF button to start the air
conditioner.
3. Press three times the TIMER SELECT
button to activate the DAILY timer.
NOTE
After timer setting, press PROGRAM button in order to
check the ON/OFF setting time.

SETTING THE 1 HOUR TIMER

This function causes the unit to operate for one hour at the
set conditions, regardless of whether the unit is on or off.
TIMER SETTING PROCEDURE.
Press four times the TIMER SEL
●
button.The 1 HOUR TIMER mark will
appear on the display.
CANCELLATION PROCEDURE
Press the ON/OFF button to turn the air conditioner off.
●
Wait for the indoor unit to stop operating.
●
Press the ON/OFF button again to turn the air conditioner
●
on.

ADJUSTING THE AIR FLOW DIRECTION

HORIZONTAL (manual)
The horizontal air flow can be adjusted by moving the
vertical vanes to the left or right, as indicated in the following
figures.
3
VERTICAL (with remote control unit)
Make sure that the remote control unit has been turned on.
the FLAP button to select the flap function
4
1
2
Fixed:
position
NOTES
Do not move the flap with your hands when the air
conditioner is running.
8
Left
Vertical vane
Continous
six oscillations
The flap automatically closes when the unit
●
is off.
When the unit starts in heating operation,
●
the fan speed will be low and the flap will be
in the 4 position until the air being blown out
of the unit begins to warm. Once the air
warms up, the flap position and fan speed
change to the settings specified with the
remote control.
CAUTION
Right
Press
Automatically
oscillations