Name Of Parts And Operation Selector Switch - Technibel MPA9FIB0R5I Operating Instructions Manual

Technibel mpa9fib0r5i; mpafia0r5i; mta8fia0r5i; mta8fbia0r5i; mtafia0r5i; mtafbia0r5i; k2fafia0r5i; k2fafib0r5i; kpa8fia0r5i; kpa9fib0r5i; ca8fia0r5i; ca9fib0r5i; ca10ficr5i; sda8fia0r5i; sda9fib0r5i; dsa10ficr5i split type air conditioners
Hide thumbs Also See for MPA9FIB0R5I:
Table of Contents

Advertisement

NAME OF PARTS AND OPERATION SELECTOR SWITCH

3
1. Remote control unit.
2. Remote control sensor: Detects the room temperature
around the remote control unit, the air conditioner is
controlled accordingly.
3. Air outlet: Conditioned air is blown out of the air
conditioner through the air outlet.
4. Air intake: Air from the room is drawn into this section
and passes through air filter which removes dust.
5. Remote control receiver: This section picks up infrared
signals from the remote control unit (Transmitter).
6. Operation selector (without remote control): Push
the button to walk through the operation modes (OFF,
COOL and HEAT)
WARNING
The OFF position does not disconnect the power. Use
the main power switch to turn off power completely.
7. OPERATION lamp: This lamp lights up during operation.
It blinks once to announce that the remote control signal
has been received and stored.
8. STANDBY lamp: This lamp lights up when the air
conditioner is connected to the power and ready to
receive the remote control command.
9. TIMER lamp: This lamp lights up when the system is
being controlled by the timer.
2
1
7
9
8
4
5
NOTES
It is possible to set the air conditioner in order to let
the OPERATION, TIMER and STANDBY lamps always
OFF, even during operation.
Be sure that CLEAN/FILTER Ti0
contemporary the IFEEL and FAN buttons on the
remote control unit for more then 5 seconds.
Repeat the same procedure to set again the normal
operation conditions.
In case of troubleshooting the air conditioner
diagnostic system activates the lamps accordingly,
even if they are set to OFF. See paragraph
TROUBLESHOOTING for further details.
MULTI SPLIT SYSTEM
The blinking of TIMER and STANDBY lamps and
OPERATION lamp ON, indicates that:
1. Indoor
unit
2. Heating mode has been selected, when the system
was in cooling mode, or vice versa.
Select the correct mode, compatible with the system.
3
6
5
8
9
7
mode is OFF. Press
2
only
has
not
been
addressed.
EG

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents