Air Filter - Technibel MPA9FIB0R5I Operating Instructions Manual

AIR FILTER

MP-MT-KPA-K MODELS
The filter behind the front panel should be checked and
cleaned at least once every two weeks.
HOW TO REMOVE THE FILTER
MP-MT MODELS
Front panel
1. Grasp both ends of the air intake grille and pull it towards
you and up.
2. Push the filter up slightly, and then pull it down. Clean the
air filter.
HOW TO REPLACE THE FILTER
Insert into the groove on the unit
1. With the «FRONT» mark facing you (if present), slide the
filter up into the unit and insert it in its place.
2. After installing the filter, close the air intake grille.
KPA MODELS
1
2
1.Grasp both ends of the air intake grille and pull to open
it.
2.Hold the air filter by the tab and pull it upward. Clean the
air filter.
3.When replacing the filter, make sure that the FRONT
mark is facing you. Reinsert the filter into place and close
the air intake grille.
K MODELS
1.Open the front panel pushing on the two points "PUSH"
and then pulling towards you.
2.Remove the air filter as shown in the figure. Clean it.
3.Replace the filter and close the front panel.
Air filter
CA-SDA-DSA MODELS
The air filter should be cleaned at least once every six
months or more frequently; it depends on the real operation
conditions.
HOW TO REMOVE THE FILTER
CA MODELS
Front panel
Air filter
L AT C H
SCREW
1.Remove the screw on each side out of the latch using a
screwdriver.
2.Press on the two latches of the air intake grille with your
thumbs in the direction of the arrow to open the grille.
3.Open the air intake grille downward.
4.Remove the air filter from the air intake grille. Clean the
air filter.
5.Insert the filter correctly again inside the grille, close the
grille letting the latches slide toward the outside and fix
again the latch with the screw on both sides.
SDA MODELS
3
1.Remove the screw.
2.Remove the filter and clean it.
3.Insert the filter again and fix the screw.
15
Air filter
Front panel
AIR INTAKE GRILLE
EG
AIR FILTER