Setting The 1 Hour Timer; Setting The Holiday Timer; Adjusting The Air Flow Direction - Technibel CAW Series Operating Instructions Manual

SETTING THE 1 HOUR TIMER

This function causes the unit to operate for one hour at the
set conditions, regardless of whether the unit is on or off.
TIMER SETTING PROCEDURE.
Press four times the
l
HOUR TIMER mark will appear on the
display.
CANCELLATION PROCEDURE
Press the ON/OFF button to turn the air conditioner off.
l
Wait for the indoor unit to stop operating.
l
Press the ON/OFF button again to turn the air conditioner
l
on.

SETTING THE HOLIDAY TIMER

The Holiday Timer function allows you to activate the
indoor unit (either it is the only one of a monosplit system
or one unit of a multisplit system), with a dalay up to
99 days you can set for the Daily Timer, On Timer, Off
Timer functions (not available for 1 HOUR TIMER) already
explained in this manual.
With this function you can set the air conditioner to be
switched on again after a long week end, a holiday of one
week or more, ecc...
To activate this function you have to follow the following
steps in order :
1. Keep pressed the button "TIMER SELECTION" of the
remote control unit (clock figure) for more than 6~7
seconds. In this way you enter the menu to select the
number of days of delay.
2. Select the desired timer (Daily Timer, On Timer,
Off Timer) pressing on the same button "TIMER
SELECTION".
3. Set the desired number of days of delay using the
button "+" .
4. Keep pressed again the button "TIMER SELECTION"
for more than 6~7 seconds. You enter again the normal
menu of the remote control unit.
At this point, the symbol of the desired timer will flash
and the selected timer will be activated only after the set
number of delay days.
3
button.The 1
C
1 - 2 - 4

ADJUSTING THE AIR FLOW DIRECTION

You can adjust the air flow direction using the 4 flaps of
the grille frame. Chose the best position according to the
operation mode and the recommended flap position.
FLAPS
HOW TO ADJUST THE FLAP DIRECTION
Fixed:
six
position
• The flap automatically closes when the unit
NOTES
is off.
• During heating operation, the fan is off and
the flap is in fixed position. Once the air
warms up, the flap position and fan speed
change according to the settings specified
with the remote control .
8
Zone «A»
for cooling and dehumidifyng
Zone «B»
for heating
Continous Automatically
oscillations oscillations
GB