Technibel MPA9FIB0R5I Operating Instructions Manual page 16

Technibel mpa9fib0r5i; mpafia0r5i; mta8fia0r5i; mta8fbia0r5i; mtafia0r5i; mtafbia0r5i; k2fafia0r5i; k2fafib0r5i; kpa8fia0r5i; kpa9fib0r5i; ca8fia0r5i; ca9fib0r5i; ca10ficr5i; sda8fia0r5i; sda9fib0r5i; dsa10ficr5i split type air conditioners
Hide thumbs Also See for MPA9FIB0R5I:
Table of Contents

Advertisement

DSA MODELS
1.
EG
2.
FILTER CLEANING
Use a vacuum cleaner to remove light dust. If there is
sticky dust on the filter, wash the filter in lukewarm, soapy
water, rinse it in clean water, and dry it.
ACTIVATED CARBON AIR FILTER
ACCESSORY SUPPLIED ON REQUEST (MP -
KPA MODELS), ACCESSORY SUPPLIED WITH
THE UNIT (AFI MODELS)
The activated carbon air filter is to be added to the standard
filter.
It is made of two layers:
- the first layer consists in a synthetic honey comb high
efficiency media to remove the dust and purifing the
air.
- the second layer in charcoal media deodorizing the
ambient air.
NOTE
1.The activated carbon air filters are in a polyethylene bag.
2.Open the bag just before installing the activated carbon air
filters, otherwise, the deodorizing effect durability of the filter
may be decreased.
WARNING
This activated carbon air filter cannot remove harmful gases
or vapors nor ventilate air in the room. You must open doors
or windows frequently when you use gas or oil heating
appliances. Otherwise there is a risk of suffocation in an
extreme case.
REPLACEMENT OF ACTIVATED CARBON AIR
FILTER
The filter is disposable.
Do not throw away the filter frame, if present.
The used filter cannot be reused even after cleaning up.
Obtain the filters for replacement at your nearest dealer.
Check the state of dirtiness at least once every two
weeks.
Replace the filter after six months' operation.
ACTIVATED CARBON AIR FILTER INSTALLATION
PROCEDURE
MP MODELS
The activated carbon air filter needs to be installed behind the
air filter.
1.Remove the air filter.
2.Install the air clean filter in the position shown in the figure
with the symbol "FRONT" facing you.
3.Reinstall the air filter.
Activated carbon
air filter
Front: white
Rear: black
Activated carbon
air filter
KPA MODELS
1. Open the unit intake air grille and pull out the standard
air filter.
2. Apply on the rear side of the filter the two spings supplied
with the accessory.
3. Fix the activated carbon filter by the springs.
4. Insert the two air filters one over the other and close
the intake grille.
REAR SIDE OF
AIR FILTER
ACTIVATED CARBON
FILTER
16
SPRING

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents