Adjusting The Air Flow Direction; Operation Without The Remote Control Unit - Technibel CA8FIA0R5I Series Operating Instructions Manual

ADJUSTING THE AIR FLOW DIRECTION

You can adjust the air flow direction using the 4 flaps of
the grille frame. Chose the best position according to the
operation mode and the recommended flap position.
HOW TO ADJUST THE FLAP DIRECTION
Press the FLAP button to select the flap function.
Fixed:
six oscillations
position
FLAPS
Zone «A» for cooling
and dehumidifyng
Zone «B»
for heating
Continous Automatical
oscillations
The flap automatically closes when the unit
l
NOTES
is off.
If automatical oscillation is selected, when
l
the unit starts in heating operation, the fan
stops and the flap is in fixed position until
the air being blown out of the unit begins to
warm. Once the air warms up, the flap
position and fan speed change to the settings
specified with the remote control.
CAUTION
Do not move the flap with your hands when the air
conditioner is running.
CAUTION
• Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
• Do not have the flap pointed down during cooling
operation. Condensation may begin to form around the
air vent and drip down.
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
If you have lost the remote control unit or it has troubles,
follow the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner push the
OPERATION selector with a pen to select the desired mode
(COOL or HEAT).
NOTE
The air conditioner will start in HIGH fan speed.
The temperature setting is 25°C for cooling mode and
21°C for heating mode.
2. WHEN THE AIR CONDITIONER IS RUNNING
If you want to turn of f the air conditioner push the
OPERATION selector with a pen until the OPERA TION
lamp is turned off.
Operation
button
POWER FAILURE DURING OPERATION
In the event of power failure, the unit will stop. When the
power is resumed, the unit will restart automatically after 3
minutes.
9
MODELS
CA8
CA9
MODELS
CA10
CA14
EG