Wall Mount Procedure - Brocade Communications Systems Mobility 650 Installation Manual

2
External antenna model wall mount instructions

Wall mount procedure

1. Orient the case on the wall by its width or length.
2. Using the arrows on one edge of the case as guides, move the edge to the
midline of the mounting area and mark points on the midline for the screws.
3. At each point, drill a hole in the wall, insert an anchor, screw into the anchor the
wall mounting screw and stop when there is 1mm between the screw head and
the wall.
NOTE
When pre-drilling a hole the recommended hole size is 2.8mm (0.11in.) if the
screws are going directly into the wall and 6mm (0.23in.) if the provided wall
anchors are being used.
12 Brocade Mobility 650 Access Point Installation Guide
53-1001934-02