Mounting The Access Point; Wall Mounting - Brocade Communications Systems Mobility 7131 Series Installation Manual

Mounting the access point

Part number
ML-5299-WPNA1-01R
ML-5299-HPA1-01R
ML-2452-APA2-01
ML-2452-PTA2M3X3-2
ML-2452-PTA3M3-036
For detailed specifications on the antennas available to the Mobility 7131 Series
Access Points, refer to the Brocade Mobility Series Access Point Product Reference
Guide or the Enterprise Wireless LAN Antenna Specification Guide. Both guides are
available at http://www.brocade.com/support/.
Mounting the access point
Both the Brocade Mobility 7131 Access Point and Brocade Mobility 7131N Access
Point can attach to a wall, mount under a suspended T-Bar or above a ceiling
(plenum or attic) following the same installation instructions. Choose one of the
following mounting options based on the physical environment of the coverage
area. Do not mount the access point in a location that has not been approved in a
site survey.

Wall mounting

Wall mounting requires hanging the access point along its width (or length) using
the pair of slots on the bottom of the unit and the access point mounting template
(on the next page) for the screws.
Brocade Mobility 7131 Series Access Point Installation Guide
53-1001935-02
Antenna type
Panel Antenna
Wide-Band Omni-Directional
Antenna
Dual-Band
Facade with 6 Element
Antenna Module
3 Port MIMO Antenna
CAUTION
An access point should be wall mounted to concrete or
plaster-wall-board (dry wall) only. Do not wall mount the access point to
combustible surfaces.
Nominal net gain (dBi)
13.0
5.0
4.0
2.0
3.0
2
9