Table of Contents
Advertisement
Introduction
The Brocade Mobility 650 Access Point links wireless 802.11a/b/g/n devices to the
controller, enabling growth of your wireless network with a cost-effective alternative
to standard access points. The Brocade Mobility 650 provides two placement
options: wall and ceiling. Wall mount slots fit onto two screws provided. Arrows on
the case guide placement of the screws. For placement above a suspended ceiling,
a safety wire tie point on the case provides for a loop of safety wire. The light pipe
fits through a hole in the ceiling tile to provide a view of the unit's status lights.
The Brocade Mobility 650 receives all power and transfers data through the same
CAT-5 or better Ethernet cable. There is no additional power supply required. An
802.3af Ethernet switch or power injector is required.
Warnings
•
Read all installation instructions and site survey reports, and verify correct
equipment installation before connecting the Brocade Mobility 650 Access
Point.
•
Remove jewelry and watches before installing this equipment.
•
Verify that the unit is grounded before connecting it to the power source.
•
Verify that any device connected to this unit is properly wired and grounded.
•
Verify there is adequate ventilation around the device, and that ambient
temperatures meet equipment operation specifications.
Site preparation
•
Consult your site survey and network analysis reports to determine specific
equipment placement, power drops, and so on.
•
Assign installation responsibility to the appropriate personnel.
•
Identify and document where all installed components are located.
•
Ensure adequate, dust-free ventilation to all installed equipment.
Brocade Mobility 650 Access Point Installation Guide
53-1001934-02
Chapter
1
1
Advertisement
Table of Contents
