Table of Contents
Advertisement
Hardware Installation
Installation instructions
The Brocade Mobility 650 mounts either on a wall with wide-shoulder screws or on
a suspended ceiling T-bar. This unit is not designed for mounting on a desk.
To prepare for installation, perform the following steps:
1. Match the model number on the purchase order with the model numbers in the
packing list and on the case of the device shipped.
2. Verify that the contents of the box include the intended Brocade Mobility 650
Access Point and that the included hardware matches the package contents
detailed in
Part number
BR-AP065060010
BR-AP065066030
BR-AP065060020
BR-AP065066040
3. Review site survey and network analysis reports to determine the location and
mounting position for the Brocade Mobility 650 Access Point.
4. Connect a CAT-5 or better Ethernet cable to a compatible 802.3af power source
and run the cable to the installation site. Ensure that there is sufficient slack
on the cable to perform the installation steps.
NOTE
When operating in a Gigabit Ethernet environment CAT-5e or CAT-6 cable is
required for Gigabit operation.
Brocade Mobility 650 Access Point Installation Guide
53-1001934-02
"Brocade Mobility 650 package contents"
Description
802.11a/b/g/n single radio integrated antenna configuration
802.11a/b/g/n dual radio integrated antenna configuration
802.11a/b/g/n single radio external antenna configuration
802.11a/b/g/n dual radio external antenna configuration
Chapter
2
on page 2.
5
Advertisement
Table of Contents
