Table of Contents
Advertisement
2
External antenna model suspended ceiling tile (plenum) mount instructions
This placement requires installation of the provided light pipe for viewing the status
lights of the unit.
Suspended ceiling mount hardware
•
Light pipe
•
Badge for light pipe
•
Safety wire (recommended) and security cable (optional)
Ceiling mount procedure
1. If possible, remove the ceiling tile from its frame and place it, finished side
down, on a work surface.
2. If required, install a safety wire, between 1.5mm (.06in.) and 2.5mm (.10in.) in
diameter, in the ceiling space.
3. If required, install and attach a security cable to the unit's lock port.
4. Mark a point on the upper or unfinished side of the tile.
5. Push the light pipe through the tile at the mark and remove the light pipe. If
necessary, use a drill to make a hole in the tile.
6. Attach appropriate antennas to the connectors.
7.
Snap the clips of the light pipe into the bottom of the case.
14
Light Pipe
Ceiling Tile
Badge
Brocade Mobility 650 Access Point Installation Guide
53-1001934-02
Advertisement
Table of Contents
