Table of Contents
Advertisement
External antenna model suspended ceiling tile (plenum) mount instructions
4. If required, loop a safety wire, between 1.5mm (.06in.) and 2.5mm (.10in.) in
diameter, around the tie post and secure the loop.
5. If required, install and attach a security cable to the unit's lock port.
6. Place the large corner of each of the case's mount slots over the screw heads.
7.
Slide the case down along the mounting surface to hang the mount slots on the
screw heads.
8. Attach appropriate antennas to the connectors.
9. Attach the Ethernet cable to the unit and to a switch with an 802.3af
compatible power source.
10. Verify the unit has power by observing that the LEDs are lit or flashing.
External antenna model suspended ceiling tile
(plenum) mount instructions
Ceiling mount requires placing the Brocade Mobility 650 above a suspended ceiling
and installing the provided light pipe for viewing the status lights of the unit.
NOTE
Notes or warnings about suspended ceiling mounts apply to all installations where
the unit is placed on suspended ceiling tile. The case has a safety wire tie point for
a standard safety wire.
Brocade Mobility 650 Access Point Installation Guide
53-1001934-02
CAUTION
Brocade does not recommend mounting the Brocade Mobility 650
directly to any suspended ceiling tile with a thickness less than
12.7mm (0.5in.) or a suspended ceiling tile with an unsupported span
greater than 660mm (26in.). Brocade strongly recommends fitting the
Brocade Mobility 650 with a safety wire suitable for the specific
installation. The safety wire should be a standard ceiling suspension
cable or equivalent steel wire between 1.59mm (.062in.) and 2.5mm
(.10in.) in diameter.
2
13
Advertisement
Table of Contents
