Dispenser - Bosch SHE55P Repair Manual

3. Disconnect both ends of the short heater
section 5.2.3 to remove right side panel for access. Tape
the wire with electrical tape to the plastic base so it can be
reconnected for resale.
4. Do NOT connect dishwasher to a water line, but slowly
pour about 4.5 liters of distilled water into the tank. The
water level should be near the bottom of the fine filter
screen in the sump.
5. Add a small amount of rinse aid and a 1/2 capful of
antibacterial agent (bacteriastat) onto the inner door. Do
NOT add bleach.
6. Reconnect the dishwasher and turn it on by pushing the
on/off button. Close the door and run dishwasher for one
minute. If necessary, add more water until level reaches
the fine filter screen.
3.4.4.3 Preparing a showroom dishwasher for resale
To return the dishwasher back to it's original condition for resale,
enter the special program mode – see section 3.4. Push button
"B" repeatedly until the display shows sales demo program mode
"P4". Push button "C" to confirm it.
702_58300000148618_ara_en_a
Push button "B" repeatedly until the display shows the original
dishwasher code (e.g. "C1", "C2", etc).
confirm it.
Turn power off and then back on. The dishwasher now has it's
original coding.
previously disconnected.
red wire – see
3.5
3.5.1
The amount of rinse-aid can be adjusted at the dispenser.
Rinse-aid can be added by pouring it onto the arrow.
3.5.2
Reconnect the pump and heater that was

Dispenser

Adjusting rinse-aid dosage
Closing dispenser doors
1.
2.
Push button "C" to
Slide cover fully left.
Push back end of the cover
(onto the arrow) down
firmly until you hear a click.
Page 9 of 42