Fault Diagnostics; Error Code Displays; Clearing Error Codes; Customer Service Test Program - Bosch SHE55P Repair Manual

6

FAULT DIAGNOSTICS

6.1

Customer service test program

6.1.1 Entering customer service test program
Controls contain codes for factory tests, customer service test
program, dishwasher configuration and error codes. Consult test
programs and error codes for your dishwasher before using the
codes from this manual.
While pushing (and holding) any two wash cycle buttons, turn the
dishwasher on with the on/off switch. After releasing the buttons,
LED "B" will be lit and LED "C" will flash, confirming you're in the
special programs menu.
To enter the test program, push button "B" repeatedly until the
digital display shows "P1" or until LED "C" is lit.
Push button "C" to start the program -- LED "C" will blink. The
steps will show on the digital display (e.g."S:01") -- push button
"B" to skip a step.
Stored error codes will show on the digital display and LED's (see

Error code displays).

The test program can only be stopped / reset by pushing the
on/off button – it can't be done by turning off the power.
702_58300000148618_ara_en_a
6.1.2 Error code displays
Error codes can be found using the customer service test
program. Most dishwashers will show the following error codes.
For dishwashers without digital displays, the "LED's" column will
show the light displays for each error code.
If there is more than one error code, the display shows the one
with the higher priority.
Dishwasher controls store error codes from the last wash cycle
(units w/o digital displays) or from the last eight wash cycles
(units w/ digital displays).
Error code E5 depends on the model, either safety float water
level reached or motor speed error. Check the test program for
the particular model.
If error code E5 is safety float water level reached, check
the float and float switch, check if water is in the base and
check if the water inlet valve has re-seated after closing.
6.1.3

Clearing error codes

To clear error codes, run the customer service test program.
Page 36 of 42