Replace The Detergent Dispenser Cover - Bosch GV550 TT Repair Manual

4.9

Replace the detergent dispenser cover

A small screwdriver can be used as a levering tool.
Prerequisite:
Appliance is disconnected from the mains.
Appliance is disconnected from water supply.
Door has been opened.
Detergent cover has been opened.
4.9.1 Remove the detergent cover
· Slide the detergent cover inwards 5 mm.
· Use a lever to remove the detergent cover from the underside
of the guide rails and remove the detergent cover from the
upper side of the guide rails.
· Remove the spring.
4.9.2 Insert the spring
· Insert the long end of the spring into the mounting hole of the
dispenser device (1).
· Insert the short edge of the spring into the mounting hole of the
detergent cover (2).
· Press the cover onto the dispenser (3).
9001630797
4.9.3 Install the detergent cover
· Insert the detergent cover into the guide rails on one side, to 5
mm before the fully open position. Gently applying force, press
the opposite side of the guide rails.
· Check
the operation of the detergent cover.
Page 23 of 35