Table 1: Supported Sfp Transceivers; Figure 3: Port And System Leds - Edge-Core SMCGS26C-Smart Installation Manual

The following table shows a list of transceiver types that have been tested with
the switch. For an updated list of vendors supplying these transceivers, contact
your local dealer. For information on the recommended standards for fiber optic
cabling, see "Fiber Optic SFP Devices" on page

Table 1: Supported SFP Transceivers

Media Standard Fiber Diameter (microns) Wavelength (nm) Maximum Distance
1000BASE-SX
1000BASE-LX
1000BASE-LH
100BASE-FX
1000BASE-T
* Maximum distance may vary for different SFP vendors.
P S
ORT AND YSTEM
The switch includes a display panel for key system and port indications that
simplify installation and network troubleshooting. The LEDs, which are located
on the front panel for easy viewing, are shown below and described in the
following tables.

Figure 3: Port and System LEDs

System LEDs
SMCGS26C-Smart
50/125
62.5/125
50/125
62.5/125
9/125
9/125
50/125 or 62.5/125
9/125
LED
S
EZ Switch 10/100/1000
45.
850
850
1300
1300
1300
1310
1550
1300
1300
Port LEDs
1 3 5 7 9 11 13 15 17 19 21 23 25
PWR
DIAG
2 4 6 8 10 12 14 16 18 20 22 24 26
– 24 –
| Introduction
C 1
HAPTER
700 m
400 m
550 m
550 m
10 km
35 km
80 km
2 km
20 km
100 m
SMCGS26C
LINK ACT
LINK ACT
Overview
*
/
/