Installing The Switching Plate; Installing The Machine Head - Brother BE-438C Instruction Manual

3-6. Installing the switching plate

3-7. Installing the machine head

2494Q
2495Q
1. Insert the head hinges (1) into the machine head so that they are parallel, and then secure them with the two set screws
(2).
2. Place the machine head gently on top of the rubber cushions (3) and cushions (4).
Note:
Pull the cords (5) out as shown in the illustration above in order to prevent them from being clamped by the machine
head.
3. Install the hinge presser (6) with the two bolts and two nuts.
4. Check that the head position switch is turned on as shown in Figure 1.
5. Connect the motor cord connector (7) to the accessory cord connector (8).
Install the switching plate (1) to the work table with the two
wood screws (2) in the position shown in the illustration.
* The switching plate and the switch bracket which is
attached to the machine head prevent the sewing
machine from starting when the machine head is tilted
back. Therefore, this means that the sewing machine will
not start if the switching plate is not installed.
2493Q
BE-438C
3. INSTALLATION
Fig. 1
2496Q
9