Adjusting The Holding Pressure; Adjusting The Position Of The Button Holder - Brother BE-438C Instruction Manual

10-9. Adjusting the holding pressure

10-10. Adjusting the position of the button holder

Loosen the adjusting nut (1) and turn the adjusting nut (2) to
the point where it is just tight enough that the material will not
slip out of place when it is slightly pulled (keep pressure as
slight as possible).
2667Q
1. Loosen the two hexagonal bolts (1) and adjust the button
holder body (2) by moving it.
2. Check that the needle will go through the button hole with
no contact. (Refer to "6. CHECKING THE SEWING
PATTERN".)
2668Q
BE-438C
10. STANDARD ADJUSTMENTS
39