Brother BE-438C Instruction Manual page 57

<Memory switches 30 - 4F>
30 to 4F are set by entering two-digit values.
These values are incremented using the P2 switch, and decremented using the P4 switch.
Switch Possible setting range
memo-30 0 - 30
memo-31 0 - 30
memo-32 12 - 27
memo-33 1 - 15
memo-34 0 - 5
memo-35 3 - 9
memo-36
memo-37 1 - 20
memo-38 1 - 20
memo-39 1 - 20
memo-3A 1 - 20
memo-3b 1 - 20
memo-3c 0 - 99
memo-3d
memo-3E
memo-3F
memo-40
memo-41
memo-42 0 - 10
memo-43
-
memo-4F
13. CHANGING SPECIAL FUNCTIONS USING THE MEMORY SWITCHES
Units
mm
mm
×100rpm
×7.5°
Stitch
×100rpm
− −
×7.5°
×7.5°
×7.5°
×7.5°
×7.5°
Stitch
− −
− −
− −
− −
− −
−
− −
Initial value
Limits the maximum area in the horizontal
direction (X).
7
(Limited to 6.4 mm when settings have
been initialized.)
Limits the maximum area in the vertical
direction (Y).
7
(Limited to 6.4 mm when settings have
been initialized.)
25 Changes the maximum sewing speed.
Changes the feed timing
10
1(Fast) ← 10 (Standard) → 15(Slow)
The (setting value + 1) number of stitches
are sewn at the speed set by memo-35 at
1
the sewing start. (No low-speed sewing if
set to 0.)
Changes the sewing start speed for the
4
number of stitches specified by memo-34
− −
Changes the feed timing one stitch be-
10 fore the sewing end.
1(Fast) ← 10 (Standard) → 20(Slow)
Changes the feed timing two stitches
10
before the sewing end.
Changes the feed timing for the third
1 stitch at the sewing start.
1(Fast) ← 10 (Standard) → 20(Slow)
Changes the feed timing for the second
1
stitch at the sewing start.
Changes the feed timing for the first stitch
1
at the sewing start.
Sets the number of stitches for which the
feed timing (memo-33 setting) is enabled.
0 0: Enabled for all stitches
1 - 99: Enabled for the specified number
of stitches from the sewing start
− −
− −
− −
− −
− −
Changes the work clamp operating
mode. (When set to "0", the mode is
0
selected according to the settings for DIP
switches A-1 and A-2.)
− −
BE-438C
Explanation
51