Arctic Cat 2007 Operator's Manual page 79

7. On Style A with the O-ring and
shim washers removed, carefully
thread the sheave adjuster back
into the driven pulley; then
tighten the adjuster with the
deflection tool/screwdriver/spark
plug wrench assembly until it bot-
toms against the driven shaft.
 NOTE:
By
sheave adjuster
driven shaft, the sheaves of the
driven pulley will spread far
enough to allow the removal of
the drive belt.
8. On Style B with the O-ring and
shim washers removed, install the
sheave adjuster and cap screw
back into the driven pulley; then
tighten the cap screw until the
sheave adjuster bottoms against
the output shaft.
 NOTE:
By
sheave adjuster against the out-
put shaft, the sheaves of the
driven pulley will spread far
enough to allow the removal of
the drive belt.
9. Remove the drive belt from the
drive clutch and driven pulley.
MAINTENANCE
741-721B
bottoming the
against the
bottoming the
Installing Drive Belt
(ACT Roller Driven
Pulley)
1. Place the drive belt (so the part
number can be read) between the
sheaves of the drive clutch first;
then between the sheaves of the
driven pulley.
2. On Style A using the deflection
tool/screwdriver/spark plug wrench
assembly,
adjuster from the end of the driven
pulley. Place the shim washers and
O-ring (as noted in removing) onto
the sheave adjuster; then carefully
thread the sheave adjuster back into
the driven pulley. Tighten the
adjuster securely using the deflec-
tion tool/screwdriver/spark plug
wrench assembly.
 NOTE: Do not over-tighten the
sheave adjuster. A torque value
of 2.1 kg-m (15 ft-lb) is recom-
mended.
3. On Style B, place the shim wash-
ers and O-ring (as noted in
removing)
adjuster; then install the cap
screw and sheave adjuster back
into the driven pulley. Tighten the
cap screw to 4.4 kg-m (32 ft-lb).
4. Close the belt guard (if applica-
ble); then install the left-side
access panel.
 NOTE: On the Crossfire/M-
Series, install the belt guard.
remove the sheave
onto the sheave
75