Table of Contents
Advertisement
10. Lubricate the rear suspension,
spindles,
adapter, and driven shaft support
bearing with a low-temperature
grease.
11. On liquid cooled models, check
the coolant level and all coolant
hoses and connections for deterio-
ration or cracks. Add properly
mixed coolant as necessary.
12. On fan cooled models, clean the
engine cooling fins and vents.
13. On 2-stroke models, place the
rear of the snowmobile on a
shielded safety stand; then start
the engine. Allow the engine to
idle; then using a long stiff wire
with a hooked end, raise the oil-
injection pump control arm to the
wide-open position
engine starts to smoke heavily.
Release the control arm and turn
off the engine.
PREPARATION AFTER STORAGE
speedometer
drive
until
14. On electric start models, charge
the battery until fully charged;
then connect the battery cables
making sure to connect the posi-
tive cable first. Test the electric
start system.
15. Inspect the entire brake system,
all controls, headlight, taillight,
brakelight, ski wear bars, and
headlight aim; adjust or replace as
necessary.
16. Adjust the track to the proper ten-
sion and alignment. Lock the jam
nuts.
the
99
Advertisement
Table of Contents
