Table of Contents
Advertisement
STEP 1: Rail Assembly & Console Mast
1. Locate the Console Mast (12) and Console Mast Cover (72); slide the Cover onto the Mast
as far as it will go. Make sure the Console Mast Cover (72) is facing the correct way.
2. At the top opening of the Main Frame (1), there is a Computer Cable (53) tied to a twist tie
wire. Feed the twist tie wire and Computer Cable (53) into the bottom of the Console Mast
(12) and out of the opening at the top.
3. Install the Console Mast (12) into the receiving bracket on the top of the Main Frame (1). Be
extremely careful not to pinch the cables between the tubing. If the cable gets pinched, this
may affect the electrical functions of the console. NOTE: there is one bolt already installed in
the receiving bracket that will engage with the slot at the bottom of the Console Mast. This
needs to be tightened last, after the three other console mast bolts.
4. Place a Split Washer (152) onto the Hex Head Bolt (105) and hand tighten through the left
side of the console mast. Place a Curved Washer (153) onto each Hex Head Bolt (103) and
thread both into the front of the console mast tube. Fasten these front bolts as tight as
possible with the wrench (155). Next firmly tighten the two left side bolts with the same
wrench.
5. Connect the two Hand Pulse Cables (47), Resistance Cable (49), and Computer Cable (53)
to the back of the console (43). Do not force the connectors; they will only fit one way and are
different sizes to prevent confusion. Store the excessive cable in the Console Mast tube (12).
6. Attach the Console (43) to the bracket of the Console Mast tube with four Phillips Head
Screws (116). Tighten the screws with the Phillips Head Screw Driver (157).
7. Attach the Rear Floor Support (15) to the Rails (2 & 3) with two Button Head Socket Bolts
(176) and Curved Washers (153) on each side. Tighten using the Combination M5 Allen
Wrench & Phillips Head Screw Driver (177).
8. Slide the Rail Assembly into the Main Frame (1). Insert one Button Head Socket Bolt (176)
through each side and attach a Flat Washer (137) and a Nyloc Nut (130) to each joint on the
inside.
HARDWARE
#137. 3/8" × 19 × 1.5T
Flat Washer (2 pcs)
#152. 3/8" × 2T
Spilt Washer (1 pc)
CUSTOMER SERVICE 1-888-707-1880
#116. M5 × 10m/m
Phillips Head Screw
(4 pcs)
#103. 3/8" × 3/4"
Hex Head Bolt (2 pcs)
#153. 3/8" × 23 × 2T
Curved Washer (6 pcs)
#130. 3/8" × 7T
Nyloc Nut (2 pcs)
6
#176. 3/8" × 2-1/4"
Button Head Socket Bolt
(6 pcs)
#105. 3/8" × 2-1/4"
Hex Head Bolt (1 pc)
Dyaco Canada Inc.©2013
Advertisement
Table of Contents
