Downloading The Firmware From The Memory Card - Kyocera FS-2020D Service Manual

(2) Downloading the firmware from the memory card

To download data written in a memory card (CompactFlash) to the printer, proceed as explained in this section.
CAUTION
Downloading firmware takes several minutes. Do not turn power off during downloading. If downloading is interrupted by
an accidental power failure, etc., the main PWB may have to be replaced.
1. Turn printer power off.
2. Remove two screws and then remove the
optional interface slot cover.
3. Insert the memory card into the printer's
memory card slot.
4. Turn printer power on.
5. Press MENU key on the printer's operation
panel and carry out the memory card for-
matting procedure (1).
6. When formatting is complete, turn printer
power off.
Memory card slot
Optional interface
slot cover
Figure 1-6-4
Message display
Ready
Press the MENU key.
Memory Card >
Press the
>Format
(1)
Press the OK key.
>Format ?
Press the OK key.
Processing
(Format information is
automatically printed.)
Ready
Figure 1-6-5
2J0/2J1/2J2
Memory card
Screw
Operation panel keys
Press the or
key.
Press the or key.
Screw
key.
1-6-3