Kyocera FS-2020D Service Manual page 87

22. Remove one connector.
23. Remove two screws-A and then remove the
HV plate.
24. Remove two screws-B and then remove the
engine R grounding plate, engine L ground-
ing plate and shield plate.
25. Check or replace the engine PWB and refit
all the removed parts.
To replace the engine PWB, remove the
EEPROM from the old engine PWB and
mount it to the new engine PWB.
EEPROM
HV plate
Screw-A
Screw-A
Connector
Engine PWB
Screw-B
Engine R
grounding plate
Engine L
grounding plate
Shield plate
Figure 1-5-39
2J0/2J1/2J2
Screw-B
1-5-29