Kyocera FS-2020D Service Manual page 102

2J0/2J1/2J2
7. Remove the formatted memory card from
the memory card slot.
8. Insert the memory card to the PC's slot or to
the adaptor.
9. Copy the firmware files to download to the
root directory of the memory card.
10. Remove the memory card from the PC's slot
or the adaptor.
11. Confirm that the printer's power switch is set
to off.
12. Insert the memory card into the printer's
memory card slot.
13. Turn printer power on.
14. When message display (1) is displayed to
detect firmware in the memory card.
15. Message display (2) is displayed during
downloading.
16. When message display (3) is displayed to
indicate downloading is finished.
17. Turn printer power off.
18. Remove the memory card from memory
card slot.
19. Refit the optional interface slot cover by two
screws.
20. Turn printer power on.
21. Confirm that message display (4) is dis-
played after warm-up.
22. Print the status page to check that the firm-
ware version has been updated (See page 1-
3-2).
1-6-4
Memory card
Figure 1-6-6
Memory card slot
Figure 1-6-7
Power switch: On
Message display
supervisor mode
(1)
supervisor mode
(2)
CF-card reading
2J0_1000.000.024
(3)
[E1F9]
Power switch: Off
Memory
card slot
Power switch: On
(4)
Ready
Figure 1-6-8
To PC
Adaptor
(Memory card read/writer)
Memory card
Product code
Firmware category
10: Engine
30: System
31: System (BROM)
Supplement (Normally: 00)
Classification (Normally: 0)
Update history
Build number
Checksum
Memory
card