The following illustration shows the connectors on the expander card. Each connector on the expander
card is used to connect a mini-SAS to mini-SAS signal cable. For detailed information, see "Connecting
the cables" on page 48.
Figure 28. Expander card
1
Connector 1
2
Connector 2
3
Connector 3
Hot-swap hard-disk-drive backplane
Your server might come with one of the following hot-swap hard-disk-drive bay and backplane configurations:
• Eight 3.5-inch hard-disk-drive bays and one backplane
• Twelve 3.5-inch hard-disk-drive bays and one backplane
• Eight 2.5-inch hard-disk-drive bays and one backplane
• Sixteen 2.5-inch hard-disk-drive bays and two backplanes
To locate the backplanes, see "Server components" on page 34.
Backplane for server models with eight 3.5-inch hard-disk-drive bays
This topic provides information to help you locate the connectors on the backplane for server models
with eight 3.5-inch hard-disk-drive bays.
44
ThinkServer RD440 User Guide and Hardware Maintenance Manual
4
Connector 4
5
Connector 5
6
Connector 6