Assigning An Ip Address Using The Cli - 3Com VCX V7122 Installation Manual

Assigning an IP
Address Using the
CLI
9 Restore your PC's IP address and subnet mask to what they originally
were. If necessary, restart your PC and re-access the V7122 via the
Embedded Web Server with its new assigned IP address.
To assign an IP address using the CLI, perform these steps:
1 Enable the Embedded Telnet Server:
a Access the V7122 Embedded Web Server (see
Embedded Web
b Set the parameter Embedded Telnet Server (under Advanced
Configuration > Network Settings > Application Settings) to
Enable (Unsecured).
c Reset the gateway. On the main menu bar, click the Maintenance
button; the Maintenance Actions screen appears. From the Burn to
FLASH drop-down list, select Yes, and then click the Reset button;
the V7122 is shut down and re-activated. A message about the
waiting period is displayed. The screen is refreshed.
2 Use a standard Telnet application to connect to the V7122 Embedded
Telnet Server.
3 Login using the username (Admin) and password (Admin).
4 At the prompt type conf, and then press Enter; the configuration folder
is accessed.
5 To check the current network parameters, at the prompt, type GCP IP,
and then press Enter; the current network settings are displayed.
6 Change the network settings by typing: SCP IP [ip_address]
[subnet_mask] [default_gateway] (e.g., SCP IP 10.13.77.7
255.255.0.0 10.13.0.1); the new settings take effect on-the-fly.
Connectivity is active at the new IP address.
This command requires you to enter all three network parameters (each
separated by a space).
7 To save the configuration, at the prompt, type SAR, and then press
Enter; the V7122 restarts with the new network settings.

Assigning an IP Address Using the CLI

Server).
Accessing the
23