Daikin ESIE13-02 Service Manual page 93

ESIE13-02
2.4.9 Symptom: Hot water does NOT reach the temperature
Possible causes
Domestic hot water flow is too high.
Temperature setting for water circuit is too low.
No heat transfer as a result of lime scale or foul-
ing in the heat exchanger domestic hot water
side.
Cold water temperature <10°C.
Error Codes: Gas Condensing Boiler
Corrective action
Adjust the inlet assembly.
Set the hot water circuit on the heat pump user
interface, depending on the desired tempera-
ture.
Descale or flush the exchanger domestic hot
water side.
The water inlet temperature is too low.
93 Part 4 – Troubleshooting
4
3
4 4
5