Table of Contents
Advertisement
Adjustment
13.
Height of the bottom feed dog
05.06
13 - 8
Requirement
When the stitch length is set at "0", at the top of its stroke the bottom feed dog 1 should
1. Be in the centre of the needle plate cutout, as seen from the side and in the direction of
sewing and
2. Be touching the feed dog adjustment gauge 2 over its whole length.
7
3
Fig. 13 - 07
Switch on the machine and with the control panel set the stitch length at "0".
Turn the balance wheel until the feed regulator motor reacts.
Bring the bottom feed dog 1 to the top of its stroke.
Raise the presser foot.
Position the feed dog adjustment gauge 2 over the needle plate cutout, with the arrow
pointing in the direction of sewing and with its front edge level with the edge of the needle
plate.
Lower the presser foot.
Adjust holder 3 (screw 4) in accordance with requirement 1.
Adjust holder 3 or eccentric 7 (screws 5 and 6) in accordance with requirement 2.
Switch off the machine.
6
5
4
1
57-34
2
Advertisement
Table of Contents
