Table of Contents
Advertisement
Input
Selecting the stitch length
Selecting seam section 1
Selecting the functions for seam section 1
- The backtacking function at the beginning of the seam (start backtacks) should be switched on.
- The presser foot should be raised at the end of the seam section.
- The machine should stop at the end of the seam section.
- The end of the seam section should be recognised by stitch counting (15 stitches).
- The seam section should be sewn at a constant speed.
11 - 3
Set the value for the stitch length at "2.0" with the corresponding +/- key.
Press the scroll key to select further seam parameters.
The values entered in the seam section "0" apply for all following seam sections,
if these are not altered within the individual seam sections.
Press the scroll key to select the first seam section.
Select seam section "1" with the corresponding +/- key.
Press the start backtack key to switch on the backtacking function at the beginning of the
seam. To enter the number of stitches for start and end backtacks see Chapter 9.09
Entering start and end backtacks.
Press the programmed stop key, to stop the machine automatically at the end of the
seam section.
Press the stitch counting key to enable recognition of the end of the seam section by the
number of stitches.
Press the speed key to sew the seam section at a constant speed (irrespective of the
pedal position).
PM
7
0
2.0
PM
7
1
2.0
Advertisement
Table of Contents
