Height Of The Bottom Feed Dog - Pfaff POWERline 2545 Adjusiment Manual

1

Height of the bottom feed dog

.05.06
Requirement
1. When the needle bar is positioned at b.d.c. (balance wheel position 180°), the bottom feed
dog should be positioned 0.5 mm horizontally above the top edge of the needle plate,
when crank 5 is in the centre of the slot.
2. In the direction of sewing, the bottom feed dog should be positioned in the centre of
the needle plate slot.
Fig. 1 - 06
● Turn lifting crank 1 (screws 2) and eccentric sleeve 3 (screws 4) according to Require-
ment 1, and set feed dog in centre of needle-plate slot as shown in Requirement 2.
www.promelectroavtomat.ru
1
2
3
The height of the bottom feed dog can also be increased or reduced as required
by moving crank 5 (nut 6) up or down.
Adjustment
2
5
127-091
4
4
6
11