Table of Contents
Advertisement
Input
Selecting seam section 6
Selecting the functions for seam section 6
- The presser foot should be raised at the end of the seam section.
- The machine should stop at the end of the seam section.
- The end of the seam section should be recognised by sensor (0.8 mm seam depth).
11 - 9
With the corresponding +/- key set the value for the seam depth at "1.5".
The actual value for the seam depth is made up of the desired seam depth and
the appropriate positive or negative correction value, when the angle on the ma-
terial is not equal to 90°.
Press the scroll key to be able to select the next seam section.
Select seam section "6" with the corresponding +/- key.
Press the programmed stop key, to stop the machine automatically at the end of the
seam section.
Press the sensor key for recognition of the end of the seam section by sensor.
PM
1.5
PM
7
5
2.0
PM
7
6
2.0
Advertisement
Table of Contents
