Table of Contents
Advertisement
Selecting the functions for seam section 8
- The backtacking function at the end of the seam (end backtacks) should be switched on.
- The thread should be trimmed at the end of the seam section.
- The presser foot should be raised after thread trimming.
- The machine should stop at the end of the seam section.
- The end of the seam section should be recognised by stitch counting (15 stitches).
- The seam section should be sewn at a constant speed.
Press the end backtack key to switch on the backtacking function at the end of the seam.
To enter the number of stitches for start and end backtacks see Chapter 9.09 Entering
start and end backtacks.
Press the foot position after trimming key to raise the presser foot after thread
trimming.
Press the programmed stop key, to stop the machine automatically at the end of the
seam section.
Press the thread trimming key to trim the thread automatically at the end of the seam
section.
Press the stitch counting key to enable recognition of the end of the seam section by the
number of stitches.
Press the speed key to sew the seam section at a constant speed (irrespective of the
pedal position).
Press the scroll key to enter the number of stitches.
PM
7
8
2.0
PM
7
8
2.0
Input
11 - 12
Advertisement
Table of Contents
