Preparation
9
Setting the remaining stitches for the bobbin thread control
.10
When the bobbin thread monitor signals that the bobbin thread has been used up, there is still
a little thread on the bobbin.
2 x
No
VAL
9 - 8
Switch on the machine.
Press the TE/Speed key twice to enter the parameter input function.
Select mechanic level "B", see Chapter13.11.02 Selecting the user level.
TE
No
760
Select the parameter "760" by pressing the corresponding +/- key.
By pressing the corresponding +/- key set the number of remaining stitches which can still
be sewn after the detection of the bobbin thread monitor (depends on the thread size).
By pressing the TE/Speed key the value is taken over and the machine changes to the
sewing mode.
The bobbin thread rest counter can only be used when parameter "660" is set at
"1", see Chapter 13.11 Parameter settings.
VAL
400