Ricoh sp 6430dn Manual page 66

3. Troubleshooting
Message
"Rplcmnt Rqrd Soon:Drum Unit"
"SD Card authenticatn.failed Error
recurs, call service."
"Set the Drum Unit correctly."
"Set the Maintenance Kit
correctly."
"Set the Toner Cartridge correctly."
"Standard Tray is full. Remove the
paper."
"Supply order has failed."
"This NetBIOS name is already in
use.(108/208)"
"The same IPv4 Address already
exists.(102/202)"
"The selected job has already been
printed or deleted."
64
Cause
You will need to replace the
drum unit soon.
Authentication from the SD
card failed.
The drum unit may not be
installed correctly.
The fusing unit may have not
been installed correctly.
The print cartridge may have
not been installed correctly.
The standard tray is full.
The automatic supply order
failed.
The NetBIOS name specified
for the printer is already used
by another device on the
network.
The IPv4 address specified for
the printer is already used by
another device on the
network.
This message might appear if
you print or delete a job from
Web Image Monitor.
Solution
Contact your sales or service
representative to obtain a new
unit.
Turn the printer off, and then
turn it on again. If the problem
persists, contact your sales or
service representative.
Turn the printer off, and then
install the drum unit again.
Turn the printer off, and then
install the fusing unit again.
If the message continues to
appear after the unit is
installed again, contact your
sales or service representative.
Turn the printer off, and install
the print cartridge again.
Remove the paper.
The message indicates the
printer tried to order the
supplies.
Contact your network
administrator.
Contact your network
administrator.
Press Exit on the message
screen.