Ricoh sp 6430dn Manual page 62

3. Troubleshooting
Message
" (Z2) Pull out Tray 1 & remove
ppr. Opn & cls F.Cov"
" (Z3) Opn Tray1/R.Cov &
remove ppr. Opn & cls F.Cov"
" Toner is almost empty."
" Add toner. Replace Toner
Cartridge."
"@Remote Cert. update failed"
"Cannot connect=>Comm.Serv.
Check proxy user/password."
"Cannot connect with DHCP server.
(101/201)"
"Cannot connect with NetWare
print server. (107/207)"
"Cannot connect with NetWare
server.(106/206)"
60
Cause
Open Tray 1 and remove the
jammed paper. To reset the
error, open the front cover
and then close it.
Open Tray 1 and the rear
cover, and then remove the
jammed paper. To reset the
error, open the front cover
and then close it.
The print cartridge is almost
empty.
The toner has run out. Replace
the print cartridge.
Updating the @Remote
certificate failed.
The proxy user name or
password is incorrect.
An IP address cannot be
obtained from the DHCP
server.
No connection with the
NetWare print server is
available.
No connection with the
NetWare print server is
available.
Solution
For details, see page 92
"Removing Jammed Paper".
For details, see page 92
"Removing Jammed Paper".
For details, see "Replacing the
Print Cartridge", Operating
Instructions.
For details, see "Replacing the
Print Cartridge", Operating
Instructions.
Turn the printer off, and then
turn it on again. If the problem
persists, contact your sales or
service representative.
Check the proxy server
settings, and then change the
user name and/or password if
they are incorrect.
Contact your network
administrator.
Contact your network
administrator.
Contact your network
administrator.