Ricoh sp 6430dn Manual page 65

Message
"Par. I/F board has a problem."
"Printer Font Error."
"Problem with Hard Disk Please
call service."
"Problem:Wireless card Please call
service."
"Replacmnt Requrd Maint. Kit"
"Rep Rqrd: Drum U. (PrtSusp)"
"Printing was suspended. It will
resume after the Drum Unit is
replaced."
"Rep Rqrd: Drum U. (PrtSusp)"
"Replace Drum Unit."
"Repl Requrd Soon Maint. Kit"
Cause
The printer's self-diagnostic
test failed due to a loopback
error.
There are problems with the
printer's font file.
The printer cannot detect the
hard disk.
The printer cannot detect a
wireless LAN interface board.
You need to replace the
maintenance kit.
You need to replace the drum
unit.
You can still continue printing
with the existing drum unit, but
print quality is not guaranteed.
If printed pages come out
blurred or with streaks or
spots, replace the drum unit
with a new one.
You will need to replace the
maintenance kit soon.
When Messages Are Displayed
Solution
Replace the IEEE 1284 board
that caused the error.
Turn the printer off, and then
turn it on again.
If the problem persists, contact
your sales or service
representative.
Check that the hard disk
installed correctly. If the
problem persists, contact your
sales or service representative.
Check that the wireless LAN
interface board installed
correctly. If the problem
persists, contact your sales or
service representative.
For details, see "Replacing
Other Consumables",
Operating Instructions.
For details, see "Replacing
Other Consumables",
Operating Instructions.
For details, see "Replacing
Other Consumables",
Operating Instructions.
Contact your sales or service
representative to obtain a new
unit.
63