Loading Paper Into The Bypass Tray - Ricoh sp 6430dn Manual

2. Loading Paper

Loading Paper into the Bypass Tray

• For details about trays that can be loaded for each paper size and type, see page 28 "Paper Size
Specifications" and page 32 "Paper Type Specifications".
• Make sure the paper stack does not exceed the upper limit mark. Excessive stacking can cause
paper jams.
• Do not mix different types of paper.
• After loading paper, specify the paper size and type using the control panel. When printing a
document, specify the same paper size and type in the printer driver as specified on the printer.
• When loading label paper, load it one by one.
• Load paper longer than A3 one by one and support it with hands so that it is fed properly.
• Paper feeding conditions and printing quality may vary depending on the paper thickness and
width. Be sure to perform test printing using the same paper beforehand.
1. While pressing and holding the bypass tray open lever in the upper center of the bypass
tray, pull the tray open.
Pull the extender out when loading A4 , 8
42
DBQ059
1
/ × 11 or larger paper.
2
DBQ120