Ricoh sp 6430dn Manual page 64

3. Troubleshooting
Message
"Exceeded max. No. of pages."
"Exceeded max. print size. Press
[FormFeed] or [JobReset]."
"Exceeded max. print size. Press
[JobReset]."
"Failed to connect to server for
Remote Diagnostics."
"Independent-supply toner"
"IPv6 Address already exists Link-
local Address(109/209)"
"IPv6 Address already exists
Stateless Address(109/209)"
"IPv6 Address already exists
Manual Config.
Address(109/209)"
"Load paper in (tray name)"
"No privileges to use funct."
"Option RAM Error"
62
Cause
While printing a Sample Print,
Locked Print, Hold Print, or
Stored Print file, the maximum
page capacity was exceeded.
The specified paper size
exceeds the maximum size
supported by this printer.
The specified paper size
exceeds the maximum size
supported by this printer.
The printer cannot
communicate with Remote
Communication Gate.
Independent-supply toner is
set.
The same IPv6 address is
already used.
The same IPv6 address is
already used.
The same IPv6 address is
already used.
There is no paper in the
specified tray.
The logged in user does not
have the privileges to register
programs or change the paper
tray settings.
The printer cannot detect an
optional SDRAM module.
Solution
• Delete unneeded files
stored in the printer.
• Reduce the number of
pages to print.
Press [Form Feed] to force
printing or [JobReset] to cancel
printing.
Press [JobReset] to cancel
printing.
Check the connection to the
Remote Server Gate.
Use the toner recommended
for this printer.
Contact your network
administrator.
Contact your network
administrator.
Contact your network
administrator.
Load the specified paper in the
tray, press [JobReset] to reset
the job.
For details about how to set
permissions, see Security
Guide.
Check that the SDRAM
module installed correctly.