Sinclair ASGE-09AIN WK Service Manual page 74

3.1.2 Bending Pipes
(1). The pipes are shaped by your hands. Be careful not to collapse them.
(2).
(3).
or stretch the pipes more than three times.
(4).
collapsed. In this case, cut the heat insulating pipe with a sharp cutter
bending the pipe as you want, be sure to put the heat insulating pipe
back on the pipe, and secure it with tape.
over.
If the pipe is bent repeatedly at the same place, it will break.
Detach the caps and plugs from the pipes.
Do not remove the flare nut until the connection pipe is to be connected so as to prevent dust and
impurities from coming into the pipe system.
and then tighten it with the spanner.
lead to leakage).
Examine the connection pipe to see if it leaks, then take the treatment of heat insulation, as shown in the
Heat insulating
CAUTION!
CAUTION!
Pipe
pipe
Cutter
Cutt line
66