Sinclair ASGE-09AIN WK Service Manual page 55

There is a drain port on both the left and right sides. Select
(7).
(8).
(9). defaulted to be the one on the left side (electric box side), the
port on right side has been plugged.
(11).
(12).
Always check that the drain cap is installed to the unused drain port and is fastened with the nylon fastener. If the drain cap is not
(13).
(14).
There is adhesive on one side of the insulation so that after removing the protective paper over it the
insulation can be directly attached to the drain hose.
Considerations for the unit with the condensate pump:
1). For the unit with the condensate pump, only one drain port at the side close to the electric box is
prepared and only through it the drain hose can be connected.
2). See table 3 for the size of the drain port of the unit with the condensate pump, which is different from
that of the unit without the condensate pump.
3). For the unit with the condensate pump, two drain ports at the bottom are defaulted to be factory
plugged with drain caps. After the installation of the drain hose, these two drain ports also need to be insulated
properly with the same way aforementioned.
4).
a.
to withstand additional force.
b.
49